Home / Vapor barriers

Crawl space vapor barriers

A vapor barrier is the liner that covers the soil so ground moisture is not free to evaporate into the crawl space. It can be a stand-alone improvement or one piece of a full encapsulation.

Many houses in this area already have something on the dirt: a thin, loose sheet left by the builder, often six mil polyethylene, sometimes only in the walkable parts of the crawl space. After ten or twenty years it is commonly torn, pulled off the walls, bunched around piers, or buried in silt. That sheet was doing a partial job when it was new. Once it is open, the soil is evaporating into the house again.

Barrier alone versus a sealed system

A vapor barrier, done carefully, covers the entire soil surface, climbs the piers, and is sealed at overlaps. It reduces the largest continuous moisture source in a dry crawl space — the ground itself. It does not close the vents, condition the air, or pump out storm water. Encapsulation adds those pieces. The right choice depends on what the inspection finds, not on which package is easier to sell.

If the space is otherwise dry, a complete, well-fastened liner can be a reasonable, lower-scope project. If humidity stays high, insulation is soaked, or water arrives after rain, a liner by itself will disappoint.

Details that change the result

  • Coverage. Edges that stop short of the wall, or piers left unwrapped, leave the soil exposed where it is often dampest.
  • Seams. Loose overlaps without tape or fasteners open as soon as someone crawls across them.
  • Thickness and reinforcement. Thicker, reinforced liners tolerate traffic and puncture better than a grocery-grade sheet. “Thicker is always better” is still a sales line; the installation quality matters more than chasing an extreme mil rating.
  • Termite inspection. In Alabama, pest inspectors often need to see a strip of foundation wall. Liners are commonly held down from the top of the wall to leave that gap. Tell the company that holds your termite bond before the work is scheduled.

If you already have a liner and you are being quoted a full encapsulation, ask what is wrong with the existing cover and whether repair or replacement of the liner would address it. Sometimes the honest answer is that the old sheet is beyond saving. Sometimes it is still doing part of the job.

A note on “mil” ratings

Mil is thousandths of an inch, not millimeters. A 6-mil builder sheet is thin and tears easily in a crawl you still have to enter for plumbing or pest control. Twenty-mil reinforced liners are a common specification for a durable cover. Extremely thick products exist and are sometimes pushed as a default. They have a place in rough, high-traffic spaces; they are not automatically the right answer for every house. Installation — coverage, seams, termination, and whether water is trapped underneath — still decides whether the barrier works.

Read how encapsulation differs and the cost guide.

Want someone to look under the house?

Request an inspection and we will connect you with an independent local specialist who serves Huntsville and nearby North Alabama communities.

North Alabama Crawl Space is a referral service. We are not a licensed contractor and we do not perform crawl space work ourselves. When you request an inspection, we share your information with an independent local specialist who serves the Huntsville area so they can contact you, inspect the space, and provide their own quote.